wind power bearing

The installation of the bearing should clean environment, small particles from entering the bearing will shorten bearing life. When replacing bearings to maintain a clean environment is very important. Allowed to tap with a hammer bearing note bearing not fall to the ground (or similar improper handling). Single Row Ball Slewing Bearing‍ Before installing the shaft and the bearing housing should also check the condition of even a small amount of wear can also lead to poor fit, thereby causing early failure of the bearing.

On the wheel hub bearing unit, do not attempt to disassemble or adjust the wheel hub bearing seals unit, otherwise it would cause water damage to seals or dust from entering. Even ring and inner ring raceway are damaged, resulting in permanent failure of the bearing.

The ring is equipped with ABS unit has a magnetic thrust bearing ring, which thrust ring can not be a collision, impact or collision with other magnetic field. Remove from the box before installation, so that they stay away from magnetic fields, such as the use of electric motors or electric tools. mobile crane bearing‍ When installing these bearings, the road test by observing the dashboard ABS alarm pin to change the bearing operation.

Equipped with ABS wheel hub bearing magnetic thrust ring, thrust ring mounted in order to determine which side, you can use a small light near the edge of something * bearings, magnetic bearings will be attracted by it generated. When installing a magnetic thrust will take the side of the ring pointing inside, is on the ABS sensor. Note: Incorrect installation may lead to functional brake system failure.

Many of the bearings are sealed, this type of bearing is not needed throughout the life of the grease increases. Other non-sealed bearings such as double row tapered roller bearings in the installation must be added grease. Because different lumen size of the bearing, it is difficult to determine how much of the added fat, the most important thing is to ensure that the grease bearing if too much fat, when the bearing is rotating, the excess conical bearing‍ oil will bleed. General Experience: During installation, the total amount of oil to account for 50% of the bearing clearance.

Install the lock nut due to the different types of bearings and bearing housings, the size difference between the torque is great. Note reference to the relevant instructions.‍